System Messages and Alarms
4.7
Alarm Monitor Window
Press
Monitor
softkey to display the Alarm Monitor Window (Figure 4.5).
Figure 4.5: Alarm Monitor Window
This window is similar to the Alarm Window, but it gives more information about the messages.
Press
Prev
,
Next
and arrow softkeys to list up and down.
Press
Exit
softkey to leave the Alarm Monitor Window.
In the Alarm Monitor Window, a message is presented in the following format
The message in-
dicator
Act — the mes-
sage status, if the
alarm is active or
not and the sys-
tem the alarm be-
longs to (see the
sections below)
Date — the date
of message initi-
ated
Time — the time
of message initi-
ated
End
—
the
time
of
alarm
acknowledging
Event — the mes-
sage text
4.8
Message Markers
Critical error, error, warning and information messages are displayed in both the Alarm Window and Alarm Monitor
Window.
Depending on their priorities, the messages are marked as follows:
for critical error;
for error;
for warning messages;
for informational messages.
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
60
Содержание NavDP 4000 Series
Страница 88: ...NAVIS NavDP 4000 Operation Manual Figure 5 35 Dark Theme 87 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
Страница 222: ...NAVIS NavDP 4000 Operation Manual Figure 10 74 Drift Plot Window 221 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
Страница 324: ...NAVIS NavDP 4000 Operation Manual Figure H 4 Remote DLS Mode 323 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
