2. Starting operation
2.1.
Assembly
The NL-82022MU must be firmly and unchangeably connected to the chassis of the
vehicle for reliable UDR operation. A temporary use in a vehicle will lead to a calibration
described in the introduction.
2.2 Microsoft Windows
Plug the USB cable in a free USB port on your notebook etc. The NL-82002U will be recognized by
your Windows operating system, which will attempt to install a driver. Abort this process, and load
the driver from u-blox
https://www.u-
blox.com/sites/default/files/ubloxGnss_vcpDeviceDriver_windows_3264_v2.30.exe
and install it.
Follow the installation instructions. After the installation is completed, restart your computer. Then
the GNSS COM port will be available in the device manager under connections. Set this port in
your navigation or route planning software. Do not use another program that accesses this port at
the same time.
2.3. Calibration ride
Check whether the receiver has a proper GNSS reception at the installation location. As a Fix
Mode, 3D must be reached.
Drive with a car with good GNSS reception signals about 20 minutes. During the journey you
must reach speeds over 30 km / h. The sensors calibrate automatically. You can see the
success of the calibration on Fix Mode, which is then on 3D + DR. From now on, the advantages of
the UDR GNSS position determination are available.
• Immediate position determination before departure. Also in a car park, in a garage or inside
house sheds
• Position determination during the journey also in a tunnel, parking garage, in a garage, in the
warehouse or in a hangar
• High navigation speed through a 20 Hz update rate of position determination
2.4 Check the sensor calibration
View \ Messages View
