Safety Information 7
EC Conformity Declaration
0063
Navien, hereby declares that the water heater models:
NPE-24AWE, NPE-24SWE, NPE-32AWE, NPE-32SWE
to which this declaration refers, conform to and comply with
the essential requirements of the following applicable European
Standards and Directives.
Gas appliances
: Directive 2009/142/EC Standards EN 437 and
EN 26
Water Heater Efficiency
: Directive 92/42/EEC
Regulation (EU) No. 814/2013
Regulation (EU) No. 812/2013
Low voltage
: Directive 2006/95/EEC
Electro-magnetic Compatibility
: Directive 2004/108/EEC
Noise
: Standard EN 15036-1, EN-ISO 3743-1
Navien, manufactures its products using a Quality Assurance
system in compliance with Standard EN-ISO 9001:2000.
Ɣ
Do not remove the front cover unless
the power to the water heater is
turned off or disconnected.
Failure to do so may result in electric
shock.
Ɣ
When servicing the controls, label all
wires prior to disconnecting them.
Failure to do so may result in wiring
errors, which can lead to improper or
dangerous operation.
Ɣ
Do not use unapproved replacement
or accessory parts.
Doing so may result in improper or
dangerous operation and will void the
manufacturer’s guarantee.
Ɣ
Do not place anything in or around
the flue terminals, such as a clothes
line, that could obstruct the air flow
in or out of the water heater.
Ɣ
This water heater has been approved
for use in the UK and Ireland only.
Using the water heater in any other
country will void the manufacturer’s
guarantee.
Ɣ
Should overheating occur or the gas
supply fail to shut off, turn off the
manual gas valve to the appliance.
Ɣ
Do not use this appliance if any part
has been under water.
Immediately call a qualified service
technician to inspect the appliance
and to replace any part of the control
system and any gas control which has
been under water.
