Navico Broadband 3G, Руководство по установке

Страница: 14 / 34

12 |
Installation | Broadband 3G/4G™ Radar Installation Guide
Connect the interconnection cable to radar interface box
To connect interconnection cable to Lowrance HDS
(USA only)
(see “Lowrance: HDS USA (no
MARPA)” on page 14)
A
B D
E
H
C
F
G
Data
Red
Yellow
Black
Shield
1. Slide (F), (E) and (D) over the RJ45 and data
wires of the scanner interconnection cable (G) 2. Connect data wires to the green terminal
block (phoenix connector)
3. Connect RJ45 and phoenix connector to
the radar interface box
H
D
A
E D
4. Secure (D) to the radar interface box using
the four supplied M3x12 black s/s screws (H) 5. Slide (E) along the cable (G) and press into
the cable gland housing (D)
A Radar interface box
B Radar data connector RJ45
C Power wires (see “Connect power”
on page 18)
D Cable gland housing
E Gland washer
F Lock nut
G scanner interconnection cable
H Screws x 4 M3x12 mm Phillips pan
head
6. Rotate (F) clockwise to secure. Firmly tighten
by hand only
• To remove the scanner interconnection cable, follow the above procedure in reverse order
• To avoid damaging the connectors when removing the scanner interconnection cable, it
is important to remove the cable gland washer before trying to remove the cable gland
housing
F
A
RADAR_3G_4G_IG_988-10113-003_EN_P.indd 12 2/11/2011 1:59:44 p.m.