Step 1 – Attach Bottom Panel to Front and Rear Frames
Step 2 – Attach Top Panel
Lay Bottom Panel (#2) on a hard surface. Be sure to protect it from scratching with cardboard or cloth.
Insert Front and Rear Frames (#3) with large flange oriented to the inside.Be sure that the slots in the
surface is facing inward.
cagenut
Attach with (Bag D) M8 Hexagon Screws (8 pcs) and (Bag E) M8 Flange Nuts (8 pcs)
Overlay the Horizontal Beams so that the notches interlay with the large flanges on the Front and Rear Frames.
The holes for the hex nut and screw should align properly. Be sure to orient the Horizontal Brams so that the flat,
Place the Top Panel (#1) on the hard surface. Be sure to protect it from scratching with cardboard or cloth.
Overlay the Horizontal Beams (#6) so that the notches interlay with the large flanges on the Front and Rear
Attach with (Bag D)
(8 pcs) and (Bag E)
(8 pcs)
M8 Hexagon Screws
M8 Flange Nuts
Turn the assembly over and insert it into the top panel. Be sure that the top and bottom Panels (#1 and #2)
are oriented in the same direction (front matches front, back matches back).
Frames. The holes for the hex nut and screw should align properly. Be sure to orient the Horizontal Beams
so that the flat, cagenut surface is facing inward.
center of the frames are facing inward as shown below.
Page 3
