BHM
11/03/13
NTV-DOC 114
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
10 |
P a g e
FAQs
Q1. I can’t get into programming mode.
A1. Turn off the vehicle and remove the key. Close all points of entry and use the remote to lock
the vehicle. Wait approx. 5 minutes without opening or disturbing the vehicle. Unlock and cycle the
ignition to the ‘RUN’ position. Make certain that the cluster is in FM radio mode before you begin
programming; and no errors are displayed (door open, etc), otherwise the cluster information might not
display. Hold down the “MUTE” button until you see the display options post on the cluster.
Q2. When I try to force (front, rear) camera, nothing happens.
A2. Make certain you’ve enabled the options you want to use in the Nav-TV settings mode.
Refer to page 8.
Q3. I hear no audio when my auxiliary source is playing on screen.
A3. Verify that the audio RCAs are connected properly to the AVSW.
Q4. Everything works properly, but when an audio source is connected to the 3.5mm audio jack,
there’s no audio.
A4. Make sure the audio RCAs are connected together on the Plug-n-Play harness.
Q5. When I place the vehicle into reverse, I get a black screen.
A5. Make sure the camera is getting sufficient power and the RCA is connected to the YELLOW
RCA behind the screen, NOT to the RCA on the UCT13.
Q6. The camera image is displayed properly when the vehicle is in reverse, but there’s only a black
screen when the camera is forced.
A6. Make sure the camera power is not connected to the reverse lamps. Camera power needs to
be connected to an accessory wire (cigarette lighter).
