BHM
01/05/14
NTV-DOC101
2 |
P a g e
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
Interface Connectors
Installation
*This car must be programmed for rear camera before installing this kit. This update can be
performed at a VW dealership, or if you have a VAG-COMM programmer you can perform the
update yourself.
1.
Remove the factory radio, disconnect all harnesses and set the radio aside.
2.
Connect the
black wire
from the provided
RGB Power Harness
to
ground.
3.
Connect the
red wire
from the provided
RGB Power Harness
to
an accessory 12v (+) source.
4.
Connect the provided
Plug & Play Video IN Harness
to the RGB-
VW.
5.
Connect the other end of the
Plug & Play Video IN Harness
to the port
of the back of the VW radio (it will only fit in one location).
6.
Connect the power plug you previously wired up (step 2 & 3) to the RGB-VW.
7.
Connect your camera’s signal to port on the RGB-VW labeled
‘VIDEO 1’
.
Power port
RGBS vs
Sync Over Green
switch (leave on RGBS)
NOT USED
Camera IN
Plug & Play RGB connector
