BHM
06/06/16
NTV-DOC260
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
8 |
P a g e
Wire side view of quad-lock
RGB-PCM3.1N Installation (in vehicle)
1.
From the main power harness, solder the following connections
to the
main radio quad-lock connector:
2.
Connect the HDMI connector (LVDS standard) from the previously modified radio to
the port on the interface labeled
‘VIDEO OUT’
.
3.
Connect your reverse camera to the yellow RCA input among the power harness
labeled
‘CAMERA’
. The purple wire from the main power harness provides 12v (+)
when in reverse only (500mA MAX).
4.
Optional:
if adding an AUX video/front camera, connect the source signal to the
secondary (female) RCA among the power harness (be certain this source is
connected to ACC power).
5.
Optional:
If using the remote to adjust ANY settings from the OSD menu, connect
the IR receiver to the port on the interface labeled
‘IR’
. Refer to page 10 for menu
adjustment details.
6.
Connect the main power harness to the RGB-PCM3.1N interface and proceed to
‘Operation’ for testing and validation.
Note:
All other included harnesses not mentioned in this manual are not needed for most
installations.
If you would like to know more about the full capability of this interface,
contact NAV-TV tech support at 561-955-9770. Additional features not mentioned in this
manual are not supported by NAV-TV at this time.
PCM3.1N Wire
Description
Connect to Radio Plug
Black
Ground (-)
PIN 12 (-)
Red
Constant 12v (+)
PIN 15 (+)
Blue
CAN HI
PIN 11 (Brown/Red)
White
CAN LO
PIN 9 (Brown)
