BHM
01/14/16
NTV-DOC034
rB2
2 |
P a g e
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
Interface Connectors
Installation
1.
Locate the factory navigation drive. These can usually be found in the trunk, glove
compartment or under the passenger seat. Disconnect all connected harnesses before
cutting any wires.
2.
Gather the provided
RGB Video Harness
and refer to the chart below for your specific
vehicle RGB pin outs. (If your vehicle is not listed, contact NAV-TV tech support at 561-
955-9770 for vehicle specific diagrams)
3.
Cut the
Red, Green, Blue and Sync wires
in
half (one at a time).
Refer to the diagram on
page 3 and make connections.
Note: RGB Ground should not be cut. Splice the ground
leads to the RGB ground (or other ground).
Note 2: While these pin locations should be
accurate, we recommend testing each wire! Refer to video:
https://www.youtube.com/watch?v=mAKbOZSv1Uo
Year(s)
Make
Model
Red Signal Green Signal Blue Signal Sync Wire RGB Ground
ALL*
ALL*
ALL*
PIN 2
PIN 7
PIN 3
PIN 8
PIN 6
1998-2000
Lexus
GS300
PIN 1
PIN 4
PIN 5
PIN 2
PIN 7
1998-2000
Lexus
GS400
PIN 8
PIN 7
PIN 6
PIN2
PIN 5
Factory connector at Navigation drive:
Power port
RGBS vs
sync-over-green
switch
(leave on RGBS)
Camera IN
RGB connector
AUX Video
*All RGB-LEX
compatible Toyota/Lexus
models
PIN 1
PIN 6
PIN 5
PIN 10
