BHM
04/23/18
NTV-DOC314
4 |
P a g e
*NOTE: in this scenario, the vehicle still must be programmed for external amp (see red note above).
ZEN-V General Installation Notes
•
This interface can be installed in vehicles with or without an amplifier & with or without MOST fiber
optic presently installed.
1.
Vehicles with fiber amplifier: the amplifier must be removed. Connect the OEM fiber previously
connected to the amp, directly into the ZEN-V.
2.
Vehicles without OEM amplifier or MOST fiber: Use the supplied fiber optic extension and
connect from the fiber port behind the radio to the MOST fiber port on the ZEN-V.
NOTE: If the
vehicle does not possess an OEM amplifier, you must program the system for external amplifier
for the ZEN-V to operate properly. Use a VAG-COM or NAV-
TV’s ZEN
-V-PRG programmer (NTV-
KIT861 sold separately).
3.
Vehicles without amplifier
but still equipped with fiber:
Disconnect the fiber from the radio,
disassemble the fiber coupler and route the provided MOST extension into the factory MOST
loop like shown below (to continue proper MOST data flow):
•
Tuning tips:
1.
Before beginning tuning process (especially with external EQ/Processors), set Bass & Treble on
the head unit for each source to flat (0).
2.
Begin with amplifier/EQ gains all the way
down.
3.
With dynamic music playing, adjust the radio volume to maximum.
4.
Adjust the amplifier/EQ gains to desired maximum level.
•
From the factory, some vehicles’ audio will
attenuate
when in reverse. Simply set the ‘reverse volume’
to desired level while in reverse
to adjust this. The ZEN-V will retain this method. The same is true for
NAV guidance audio and BT voice calls.
Содержание NTV-KIT860
Страница 10: ...BHM 04 23 18 NTV DOC314 10 P a g e...
