NNG-GM2 (LVDS MYLINK/CUE) 8” Navigation Installation
3 |
P a g e
NNG-GM2 Installation Steps
1.
Remove factory radio touch screen assembly from dash
2.
Locate (1) video plug and (1) screen power / data plug
3.
Plug in the LCD T-harness cable (blue) to factory screen and factory harness
4.
Plug in the main Power / Data T-harness (10-pin or 16-pin) to factory screen and
factory harness
5.
Connect Audio Switch Box to Main Harness (2 connections)
6.
Install GPS Antenna (best GPS antenna location is under passenger side A-pillar,
on top of dash. Or under dash plastic cover towards the windshield)
7.
Connect Power plug to GPS Box (POWER label)
8.
Connect LCD (blue) cable to GPS Box (LCD IN / OUT label)
9.
Connect A/V harness to GPS Box (A/V label)
10. Connect and install Switch to dash and to A/V harness
11. Connect GPS Antenna to GPS Box
12. Route and connect Speaker T-harness to dash speaker (GM vehicle mostly
equipped with dash top speakers, either located at center or driver side of dash.
If no dash top speaker is provided, please refer to diagram below for audio
integration to factory driver door speaker)
Installation Remarks
1.
Addition wires are provided in the Main Harness for testing purpose only. Those
wires include Audio Out (3.5mm), Rev Trigger (orange), ACC (red) and Camera
Input (RCA). DO NOT USE THESE WIRE FOR INSTALLATION.
2.
If there is no factory top dash speaker, please make following connection
from
Audio Switch Box as indicated
(see next page).
NTV-DOC216
