LOCATION & REMOVAL
INSTALLATION
INSTALLATION
Important note;
Switch off car and remove key, wait 10 minutes
before removing any factory connectors.
Installation is made at the front monitor on all models,
you will need to remove the monitor by removing the
two screws shown below.
Next unplug the silver 10 way plug and black 12 way
plug from the monitor and remove from the car.
You may choose to mount the interface behind the
glove box area, which is easily removed with screws
at the front and underside of the glove box itself.
Power and CAN connections
Power and CAN connections are made at the 12 way BLACK
plug from the screen unit.
You will need to connect the supplied 10 way WHITE plug loom
on to;
CAR
connect to
NAV-INBMW3
PIN 5 (BLACK)
to
PIN 5 (BLACK)
PIN 5 (ORANGE/GREEN) (X5)
to
PIN 5
(BLACK)
PIN 6 (YELLOW)
to
PIN 10 (YELLOW)
PIN 6 (GREEN) (X5)
to
PIN 10
(YELLOW)
PIN 1 (RED 12v+ perm)
to
PIN 1
(RED)
PIN 3 (BROWN12v– GROUND)
to
PIN 2
(BROWN)
See “Operating Instructions” for;
PIN 3 12v– out (WHITE)
Plug the WHITE plug in to the socket in the interface marked
SUPPLY,
FINALLY AFTER ALL OTHER CONNECTIONS.
AND REMOVE POWER FIRST BEFORE REMOVING ANY
OTHER CONNECTIONS. FAILURE CAN CAUSE FAULTS
Video connections
Connect the shorter of the supplied GREY cables to the silver
male 10 way plug of the car harness (removed from the
screen)
Next connect the shorter of the supplied grey cables to
the black socket marked INPUT TO HARNESS on the
interface (see below)
Next plug in the longer of the supplied grey cables to
the metal screen socket,
and to the black socket marked OUTPUT TO SCREEN
on the interface (see below)
Connect your added video sources / camera to the
composite or RGB inputs shown below
INPUT OUTPUT SUPPLY
