BHM
11/01/18
NTV-DOC163
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 |
P a g e
OEM GVIF Radio
Installation
1.
Remove the factory radio. This usually requires pulling panels and removing a series of
screws. Disconnect any associated harnesses and set the radio aside.
2.
Gather the provided
‘Power/CAN Harness’
from the GVIF-CTS kit. Connect the
following wires to the car:
Note: CAN connection is not supported at this time. You must connect the GRAY wire
to a reverse lamp for reverse activation!
3.
Disconnect the factory GVIF cable from the factory
radio, this is square, blue connector.
4.
Connect the
male side (labeled ‘L
X
IN’) of the
provided
GVIF video cable
to the factory radio.
5.
Connect the free end (removed in step 3) of the factory
GVIF video cable to the female side of the provided
GVIF
video cable
(labeled ‘LXOUT’).
6.
Connect the white end of the GVIF video cable to the
interface at the port labeled
‘LVDS IN/OUT’
.
7.
Connect the AV Input cable to the port on the GVIF-CTS interface labeled
‘AV IN/OUT’
. If
you’re only connecting a reverse camera (and no other
inputs), the signal input from the camera must connect
to the RCA labeled
‘REAR
-
C’
. Refer to the dip-
switch settings chart to skip/enable AV sources
upon toggle switch presses (optional. Page 2).
8.
Adjust dip switches on the GVIF-CTS interface properly, refer to the chart on page 2 for
qualifications.
9.
Connect the white plug from the
‘Power/CAN Harness’
to the port on the GVIF-CTS
interface labeled
‘Power/CAN’
.
Interface wires
Connect to car
Black (GND)
Chassis Ground
Red (ACC)
Accessory
Gray (Rear)
Reverse lamp 12v (Pin 2, Pink conn @ BCM)
(only if adding rear camera)