Nautilus BE STRONG. NS 600X, Инструкция по сборке, Страница: 12 / 22

1
39
38
37
36
35
15
14
47
45
12
46
13
40
41
82 1/4"L
82 1/4"L
71
ASSEmBLY
STEP 4
# Component Qty
Step 4 Components:
Procedure:
a
. Attach Press Arm Support Assembly (12) to the Top Frame using the Press Arm
Support Shaft (45). Align shaft and tighten with 4 set screws (82) as shown.
B
. Attach Press Arm (13) to Press Arm Support Assembly (12) using the Press Arm
Pivot Shaft (46). Pull Back on Press Arm Pop Pin or remove for ease of assembly.
Align Shaft and tighten two set screws (82) as shown.
c
. Attach Press Arm Handles (14) (15) using the hardware shown. Tighten hardware
firmly.
D
. Slide the Roller Bar (41) through the Leg Extension tube. Either of the bottom two
holes can be used depending on best fit for user.
e
. Slide a Plastic Washer (39) followed by a Foam Roller Pad (36) on the Roller Bar
(41). Press the Roller End Cap (38) firmly into the Roller Bar (41). Repeat for the
opposite side.
f.
Slide the Locking Roller Bar (40) through the leg extension tube as shown making
sure that it is centered. Slide the Locking Roller Pad (35) on the Locking Roller
Bar (40). Press the Locking Roller End Cap (37) into the Locking Roller Bar (40).
Repeat for the opposite side making sure that the Locking Rollers are aligned.
12
13
14
15
35
36
37
38
39
40
41
45
46
47
71
99
82
Press Arm Support Assembly
Press Arm
Right Press Arm Handle
Left Press Arm Handle
Locking Roller Pad
Foam Roller Pad 8”L
Locking Roller End Cap
Roller End Cap
Plastic Washer
Locking Roller Bar
Roller Bar
Press Arm Support Shaft
Press Arm Pivot Shaft
Snap Cap Large
Button Head Screw 3/4”L
3/8” Curved Washer
Set Screw 5/16” x 1/4”L
1
1
1
1
2
2
2
2
2
1
1
1
1
2
4
4
6
99