Nautilus Hyosung MONiMAX8200QTN, Руководство оператора

Страница: 57 / 120

Chapter4. Receipt Printer (SPR60) Operator Manual
4-16 © Nautilus Hyosung, Inc. All Rights Reserved.
► Problems during paper output
Problems Possible reasons Solutions
The printer stops printing
and warns errors during
printing.
Paper end;
Paper jams in cutter; Dust or
wastepaper covers the paper
near end sensor. Install a new paper roll;
Check if there are sundries in
cutter path;
Clean the paper near end sensor.
<Problems during paper output>
<Note!> Contaminated paper may cause detection failure.
► Other problems
Problem Possible reasons Solutions
LED does not light and
printer does not work.
The printer is not connected
with the power correctly.
The printer isn’t turned on. Connect the printer with power
correctly.
Turn on the printer.
The printer does not work
after receiving
commands.
Printer is in error status. The
communication cable is not
connected well. Interface
setting is wrong.
Remove the errors(
＊
)
Make sure the communication
cable is connected correctly.
Set the interface again according
to the self-test page.
<Other problems>
<Note!> Paper near end alarm acts only as a prompt for users, not an error status. Therefore when
this alarm is given, printing task can still be sent.