Service Manual Chapter7. Cash Dispenser Unit
© 2013
Nautilus Hyosung Inc.
All Rights Reserved.
7-34
Cassette Identification Sensor (CS12, CS22, CS32, CS42)
► Cassette Identification Sensor (CS12, CS22, CS32, CS42)
1. In case of replacing the cassette identification senor (CS12) on first feeding module,
you should firstly remove the electronic control board. On other feeding modules,
you can skip this step.
2. In case of replacing the cassette identification senor (CS22) on second feeding
module, you should firstly remove the cable guide bracket. On other feeding
modules, you can skip this step.
3. Loosen M3 fixing screw (each 2 places) of the Sensor Bracket.
4. Remove the connector and the cable tie to remove the Sensor Bracket. Be careful
not to break the connector pin when removing.
5. Replace the sensor.
6. Assemble in the order of 4~1.
