PR500 Bracket Assembly
(Used in Smart Tabs ProTrollerSeries Kits and Plate Retractor Kits)
Finished Install
1.
Insure all the below hardware is in you kit
#SCR1434
1/4” Sheet Metal Screw
#Nw516
5/16” Nylon Washer
#Jn516
5/16 Jam nut
#La500
Lever Arms
#efps-140
eyelet end fittings
#Lh500
Lever Handle
Pr500 Mounting
Bracket
5/16” Hex Screw
5/16”Maching Screw
2.
Change out the Top end fitting by unscrewing
from the actuator. You will only need to
do this if you have the SX trim tabs.
Remove
Use
3.
Lever Arm Layout
Insert the 5/16”hex head bolt through
the 5/16” eyelet hole in the end fitting
of the actuator and then attach the
5/16” jam nut snugly hand tight.
4.
Slide the lever arm over
the bolt and attach the handle.
( Its recommended to put
threadlocker on the handle threads)
5.
Hold the lever arm handle
with a 7/16” wrench and the 5/16” hex
bolt with a ½”wrench and tighten well.
Note: Insure that the actuator can
rotate freely, but remains snug.
6.
Lever Handle Layout
Attach the lever arm to the
PR500 Bracket using the 5/16”phillips
head machine screw and self locking nut.
Use the black nylon washers on each
side of the bracket. Tighten securely, but
not too much. The handle should rotate
with minimal force.
www.nauticusinc.com
(Threadlocker inside handle
recommended)
