13
Setting up the moisture alarm
2.
Switch on the alarm. The LED light
will turn blue for five seconds
indicating the battery is normal.
Then it goes into flashing blue light
standby mode.
(Optional) Vacuum valve (25056-
25061) can be attached to the
housing via one of the accessory
port for conducting a vacuum seal
test. Please refer to the manual of
the vacuum valve for more details
of the operation.
1.
Install the CR2450 battery provided
into the battery compartment on
the circuit board inside the rear part
of the housing.
3.
Test the alarm by contacting the two
wires near the bottom of the
housing with a damped cotton bud;
the alarm should start giving out a
repeating “beep” sound along with
a flashing red light. The “beep”
sound and the light should keep on
going for 5 seconds after the
removal of the damped cotton bud .
