5.
Remove the O-ring from A, inspect for any
damage and lightly coat it with the provided
lubricant. Clean the O-ring groove before
placing it back.
6.
Verify that the threaded section of B and
sealing surface are clean and free from foreign
material.
7.
Align the external threaded section of A and
the internal threaded section of B.
4.
Make sure the zoom knob is at its most
outwards position before mounting/ un-
mounting the lens. The knob should be left at
this position until it is made sure that the lens
and zoom gear is properly installed.
8.
Attach A on B by holding the housing firmly and
turning A clockwise until it cannot go in any
further.
9.
Engage the gear by pushing in the knob, then
turn the knob both ways to check if the lens
zoom in and out.
10.
To un-mount the port, reverse the above steps.
A
