Nautel NX5 AM, Руководство по предварительной установке

Страница: 31 / 89

NX5 PRE-INSTALLATION MANUAL PHYSICAL REQUIREMENTS
PAGE 1.3.2 VERSION 0.1 2015-08-01
Preparing to Move the Transmitter into Place
The NX5 is designed for ease of movement into its final position. Consider the following when planning
your installation:
 An integrated pallet at the bottom of the cabinet accepts the forks of a forklift or a pallet jack
(see
Figure 1.3.3 on page 1.3.6 ). The pallet opening runs front through rear, is 17 inches
(43 cm) wide, 3.5 inches (9 cm) high and 7/8 inches (2 cm) above the floor level. Lifting access
is from front to rear so plan for appropriate lifting equipment clearances. Ensure the forlift or
pallet jack is capable of lifting the transmitter’s weight (see
“Weight” ).
 If you are planing to use a forklift, make sure that its two forks will fit together within the
17-inch (43 cm) wide space.
 If you are planning to use a pallet jack, arrange for a 27-inch wide jack. Only one fork of the
pallet jack will be used, but it can be centered under the transmitter cabinet. Nautel also
recommends arranging for an additional person who can assist with stabilizing the
transmitter while it is being lifted and moved by the pallet jack operator.
 Nautel provides casters that can be installed on the bottom of the cabinet to allow the
transmitter to be rolled into place. This method requires less clearance (i.e., no forklift) in front
of the transmitter’s final location.
Weight
The fully assembled NX5 weighs 317 kg (696 lbs) crated and 261 kg (573 lbs) uncrated.
NOTE:
Weight includes the power transformer, which is installed in the transmitter for shipping.
Dimensions
The NX5 main transmitter has the following overall dimensions. See Figure 1.3.1 through Figure 1.3.5
for detailed dimensional views.
 Height: 184.2 cm (72.5 in)
 Width: 58.7 cm (23.1 in)
 Depth: 86.0 cm (33.9 in) with air filter installed; 82.8 cm (32.6 in) without air filter