Nautel NX15, Руководство пользователя

Страница: 14 / 19

Page 12
NX15-NX100 Transmitters - Replacing the Single-Board Computer (SBC)
Issue 1.0 FM13016D
3 REBOOT & TOUCHSCREEN CALIBRATION
IMPORTANT
Inserting a new compact flash card or SSD drive will prompt a software upgrade which
requires the transmitter to be “off-air”. Various settings (i.e.; User Accounts, Network Setup,
Email Configuration, Notifications, NTP Servers) and logged data will not be saved in the
transmitter when you replace the compact flash card.
NOTE
The OS password document, provided with the transmitter, should be kept in a secure
location for future reference. This password is needed in the event access is required to the
transmitter’s operating system.
(a) If the AUI fails to load and the BIOS boot setting was confirmed, the compact flash card
or SSD drive may be corrupted. Turn RF Off and disconnect power to the SBC (P30
connector).
(b) Remove the old flash card or SSD drive and insert the replacement programmed SSD
Mod (Nautel Part # 219-2131) provided with the Field Modification kit.
(c) Re-connect power to the SBC (P30 connector) and verify BIOS boot settings again (refer
to IS18005).
(d) The touchscreen monitor will turn on and a screen will appear prompting you to perform a
software upgrade. The AUI will not navigate away from this page until it has been
completed. Plug in the USB mouse and begin the upgrade. Refer to the Non-standard
Maintenance section of the transmitter's Operations and Maintenance Manual if you
require assistance with installing the software.
(e) Login to the AUI using the default username “
Nautel ” leaving the password blank.
(f) Perform a touch screen calibration through the AUI (in Menu
► System Settings ►
Screen Configuration). Using the USB mouse to navigate to the touch screen calibration
page, and then use your finger to touch the targets.
(g) Do an ac power cycle after the software upgrade and touch screen calibration is finished.
(h) Unplug the USB mouse and reconfigure the network settings in the Network Setup page
(in Menu ► User Settings).
(i) Reconfigure the User Accounts settings (in Menu
► User Accounts), Email
Configuration, Notifications, NTP Servers, Nautel Phone Home, SNMP Configuration
settings (in Menu
► User Settings) and Audio Player settings (in Menu ► Audio Player,
then enable in Presets menu).
(j) Turn RF On and return to normal operation.
The modification is complete.