Nautel NV30LT-N, Руководство по эксплуатации и техническому обслуживанию

Страница: 190 / 226

NV30LT-N OPERATIONS & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
PAGE 3.2.172 VERSION 0.1 2015-03-01
Configuring the Transmitter for the Orban Audio Processor
NOTE
: Audio processor configuration is only available using the front panel display.
Configure the NV30LT-N to recognize the presence of the Orban card using the front panel UI as
follows:
1. With the transmitter turned on and in local mode of operation, navigate to the front panel UI's
Main Menu -> System Settings -> HW Config
menu. Scroll down through this menu and select
Audio Processor
(see Figure 3.2.151 ).
2. In the
Audio Processor
screen (see Figure 3.2.151 ), use the up and down buttons to toggle
between
None
and
Orban Inside
(default factory seting is
None
). Select
Orban Inside
to enable
the Orban audio processor for use (selecting
None
disables it). Press the accept (checkmark)
button to save the change. Press cancel (
X
) to discard changes and return to the previous menu.
3. Reboot the transmitter by switching the ac power off and then on. This will ensure the transmitter
properly detects the Orban Inside card upon recovery.
Figure 3.2.151: Configuring the Transmitter - Front Panel UI HW Config and Audio Processor screens