Page 2
NV Series – Software Update Procedure
Issue 1.1
IS09004D
(d) Install the new card (noting
orientation) and plug in SBC power
connector P8.
(e) The AUI should boot up and the
transmitter login screen should appear
(or the main screen – depending if
Auto Login
was enabled for the active
user).
(f) Proceed to paragraph 5.
4 TRANSFERRING UPGRADE FILE
The following steps assume either the
laptop will be used to connect directly to
the transmitter
OR
the transmitter and
network computer are currently connected
to the same network.
4.1 Transmitter IP Configuration
(a) From the transmitter AUI, go to
Menu
/
Software Configuration
/
Network
Setup
.
(b) Record your current network settings
(IP address, Subnet Mask, Default
Gateway).
(c) If connecting to the transmitter directly
with a laptop, select ‘
Static IP
’ and set
as follows:
IP
Address:
10.10.10.2
Subnet
Mask:
255.255.255.0
Default
Gateway:
192.168.1.2
Press
Apply
then
Reboot Now
.
(d) Set the transmitter for
Remote
control.
4.2 Laptop IP Setup
The following steps assume the operating
system is
Windows XP
; adapt as required
for computers with different operating
systems.
(a) On the laptop, go to
Start Menu
/
Control Panel
/
Network
Connections
/
Local Area Network
.
(b) In the Local Area Network Status,
open the
General
tab and choose
Properties
. Scroll down and highlight
Internet Protocol (TCP/IP)
. Choose
Properties
.
(c) In the
Internet Protocol (TCP/IP)
Properties
window, select
Use the
following IP address
.
(d) Enter the following settings:
IP Address:
10.10.10.1
Subnet Mask:
255.255.255.0
Default Gateway:
192.168.1.2
(e) In the
Internet Protocol (TCP/IP)
Properties
window, select
OK
.
(f) In
the
Local Area Connection
Properties
window, select
OK
.
(g) In the
Local Area Connection Status
window, select
Close
.
(h) Close the
Network Connections
window.
Содержание NV Series
Страница 2: ......