Nautel NARF79, Руководство по установке

Страница: 62 / 86

VX150 TO VX2 INSTALLATION MANUAL COMPLETING EXTERNAL CONNECTIONS
PAGE 1.10.6 VERSION 0.3 2021-01-14
Connecting Program Inputs
1. Make sure you have completed the planning requirements described in Section 1.7, “Program
Inputs” on page 1.7.1 before proceeding.
2. Route the desired analog and digital program input cables to the back of the of the transmitter.
3. Obtain two ferrite toroids (Nautel Part # LXP38, 19 mm inner diameter) from the Ancillary kit.
4. Pass all program input cables through the ferrite toroids obtained in Step 3 . If practical, wires
should pass through a minimum of two times (two turns) (see Figure 1.10.4 on page 1.10.7 ).
Position the ferrite toroids just outside, or just inside, the program inputs to the transmitter.
Figure 1.10.3: Passing program input wiring through ferrite toroids
5. With the program input cables near the rear of the transmitter, cut each wire to the required
length, and install connectors, as necessary.
6. Remove plastic cap-plugs from the connectors on the rear panel, if applicable.
Audio Input Cables
(to transmitter
rear panel)
LXP38
ferrite toroids