Nautel Exporter Plus, Техническое руководство по эксплуатации, Страница: 45 / 186

Exporter Plus Technical Instruction Manual Quick setup procedure
Issue 1.0 2020-05-05 Page 6-7
Configuring the exciter
The Exporter Plus must be able to connect to an exciter. To perform this task, you must
obtain the IP address and exciter link port number for the exciter. If the IP connection
between the Exporter Plus and the exciter is unidirectional, then you will also need the MAC
address of the exciter.
The selection of exciter link port number is somewhat arbitrary, but it must be set to the same
value in both the Exporter Plus and the exciter (Exgine configuration setup). Nautel
recommends a value of 9000.
Configure the network information for the exciter and Exgine, if necessary, as follows:
Figure 6.5: Exciter Configuration
1. Enter the UI’s
Edit Settings - Exciter Config
page (see Figure 6.5 ).
2. Select the appropriate item from the
EXCITER
list and configure the E2X protocol, IP
address, port number and MAC address. It is only necessary to set MAC address if the
network connection to the exciter is unidirectional, which is common with some types
of digital STLs.
3. Set
MAC Address Enable
to
Yes
if MAC address configuration was required.