natus XLTEK Protektor32, Инструкция по эксплуатации

Страница: 15 / 81

XLTEK Protektor32 Instructions for Use
13
stimulation pulse duration ranges from 0.05 ms to 1.0 ms. Pulses are repetitive up to a maximum
frequency of 500 Hz.
Electrostatic Discharge (ESD) handling procedures and warnings
Before performing any setup or placement procedures, it is recommended that all clinical staff read and/or
are trained on the precautions outlined in this section.
WARNING:
Be sure to take the appropriate Electrostatic Discharge (ESD) precautions.
Disconnect the cables before moving, cabling, or performing any set up procedures.
Some semiconductor (solid state) devices can be easily damaged by static electricity.
Such components are commonly called Electrostatically Sensitive Devices (ESD). Do not
touch the accessible conductive parts for the Connectors marked with the ESD symbol.
Follow these techniques to help reduce the incidence of component damage caused by
static electricity:
•
Immediately before handling any product components assemblies, drain the electrostatic charge from
your body by touching a known earth ground.
• Minimize body motions when handling unpackaged replacement ESDs. Motions such as brushing
clothes together or lifting your foot from a carpeted floor can generate enough static electricity to
damage the product components.
•
Avoid carpets in cool, dry areas. If provided, leave the product components in their anti-static
packaging until ready to be installed.
• Take care when connecting or disconnecting cables. When disconnecting a cable, always pull on the
cable connector or strain-relief loop, not on the cable itself.
WARNING:
A damaged cable can cause a short in the electrical circuit. Prevent damage to
the connectors by aligning connector pins before you connect the cable.
WARNING: Misaligned connector pins can cause damage to system components at power-
on.