37
Using the Control Panel Arrow Keys
The arrow keys marked with can be used to select the site
.
They select / activate the sites one by one:
•
(up) and (down) selects next site.
•
(right) and (left) are related to the marker selection, described in the
section below.
Using Test Function Keys
The ‘New site’ function key selects the next stimulation site from the stimulation sequence.
Other functions of the Control Panel (general to all test types):
The arrow key marked with
, modify the sweep and the sensitivity affecting all sites with the same signal type as the currently active sites.
Sweep Speed:
•
To increase the sweep speed: click > (right).
•
To decrease the sweep speed: click < (left).
Sensitivity Level:
•
To increase the sensitivity level: click (up).
•
To decrease the sensitivity level: click (down).
Saving the Recorded Traces
The last trace is automatically saved. All recorded traces may be saved either automatically by selecting the
Auto-Move to
function in the
History Window (
7
) (recommended) or by clicking the
Move to History
button manually.
NOTE
Each site has its own history.
The History and Acquire Views
•
Click the show all traces button
to show all traces for the site.
•
Click the show selected trace button
to show the selected trace only.
•
The selected trace is marked in blue. A new trace always becomes the selected trace. Double click or right click on specific trace to
select another.
•
Use the History panel in the right hand side of the screen for additional display options for the selected site(s).
Stimulation Settings
The stimulation settings are predefined but can be changed through the local test settings. The stimulation settings can be changed using
the mouse or the Control Panel.
Us
ing the Mouse
The stimulation settings bar allows change of the stimulation parameters, i.e. the waveform and the frequency, while the test is running. At
the top of the scope window, click the button and select the value from the drop-down list.
Using the Control Panel
The
Stimulus Duration
button sets the stimulus duration as follows:
•
To increase the duration: click (up
).
•
To decrease the duration: click (do
wn).
The
Repetition Rate
sets the repetition frequency as follows:
•
To increase the repetition rate: click (up).
•
To decrease the repetition rate: click (down).
•
Press the Single
Stimulus
button to activate the single stimulus pulses or to stop the repetitive stimulation mode.
