Part III
Maintenance
1
General Information
Please perform the following maintenance work at least once a month:
• Clean and grease the axle.
• Check the wheel sockets and the fixed plates. Exchange them, if necessary.
• Tighten the self-locking screws. Exchange them (for instance – but not exclusively – if
the top no longer maintains the adjusted position), if necessary.
• Check all screw connections. Tighten the screws, if necessary.
• Oil all movable parts (springs, hinges).
• Oil all brake parts (brake cable, brake spring, brake bolt).
• Rid small paint damages of dirt and rust with fine sandpaper. Afterwards, carefully
apply a new coating layer to the affected areas with a paint stick from a specialist shop,
according to the instructions.
WARNING!
Please note that the stroller needs to be cleaned after every use under certain
environmental conditions (proximity to the ocean, grit, contact with sand, etc.).
WARNING!
Whenever your stroller comes in contact with cleaning agents, please note
that the corresponding parts of the stroller need to be oiled.
WARNING!
Avoid bumping axles or wheels into things – this prevents the deformation of
the frame! A frame that has been deformed by mechanical force cannot be used any
more and does not consitute a warranty claim.
2
Brake Maintenance
1. Remove the back wheels and grease their axles.
2. Actuate the brake and oil the brake pin at both rear suspensions.
23
