https://www.naturewater.eu
Item 63452
Page 7
08 2022-1
Guide to operation
First use
1.
Place the device on a table, cupboard, or flat surface.
2.
Remove the water tank and add tap water to the highest MAX water level. Then replace the
tank on the device.
3.
Connect the device to the power supply.
4.
The device automatically flushes the filter system and the piping for 2
min.
5.
After rinsing, the water in the tank should be drained to fill it with tap water.
6.
The device automatically starts water treatment. After the treatment is finished, it can be used
normally (the water must be changed once in the whole treatment process to fill up the internal
water tank).
7.
To obtain excellent water quality, it is recommended to press and hold the “
” (rinse) button
for 3
s to rinse manually. Repeat this 3 times.
Daily use
The product supports 6
types of water temperature for selection. Water can be taken directly by pressing
the “25
℃
”, “45
℃
”, and “55
℃
” buttons. The other 3
temperature buttons can be pressed to get water
after the unlock button has been pressed.
Notice!
Pressing any temperature key during water withdrawal stops the water dispensing.
Caution!
•
This machine is equipped with a quantitative water outlet protection. If the amount of water
exceeds 500
mℓ, the water outlet will stop automatically.
•
When taking out hot water, do not reach your hand under the water outlet.
Risk of scalding!
•
When you switch on the device for the first time to draw off hot water, first put in some room
temperature water and then the hot water.
Risk of scalding!
•
Unlock button: ock when no water comes out.
Water change
If the “ ow water” indicator lights up, it means that there is not enough water in the raw water tank. Pour
out the water in the raw water tank and replace it with tap water.
Idle state
If no water draw-off button is pressed within 1
hour after the last water production, the machine will
automatically go into sleep mode to save power. When any water-temperature button is touched, the
machine is activated and then goes into standby mode.
