Page of 6
4
USE AND CARE
•
Do not modify the product
in any way.
Unauthorized modification may impair the function and/or safety and
could affect the life of the equipment. There are specific applications for which the product was designed.
•
Always check of damaged or worn out parts before using the product.
Broken parts will affect the products
operation. Replace or repair damaged or worn parts immediately.
•
Store idle product.
When the product is not in use, store it in a secure place out of the reach of children.
Inspect it for good working condition prior to storage and before re-‐use.
Solar Security Light 1000 Installation
1.
Using the Quick-‐clip mounting bracket located to the rear of the Light to mark where you want to install the
7W COB LED Light.
2.
Make sure this is clear of obstacles such as cables and electric lines.
3.
Secure the Quick-‐clip mounting bracket to the wall with screws provided.
4.
Carefully route the power cord from the solar panel to the Light and plug it into the recharging port.
5.
Adjust the Solar Security Light 1000 so that it faces the area where is most likely to be illuminated. You can
move it up and down, right and left by adjusting the neck of the Solar Security Light 1000.
Noted: Solar Security Light 1000 should be mounted 2-‐3 meters (6.5-‐9.8ft) from the ground to ensure motion
detection is optimized.
OPERATION
1. Located on the front of the light there is a switch with 2 positions.
1.1. ‘Auto’ – When the switch is in the ‘Auto’ position the Solar Security Light 1000
will turn on
automatically at night once motion is detected.
1.2. ‘Off’ – When the switch is in the ‘Off’ position the Solar Security Light 1000 will remain off and will
not detect any movement.
2. To choose high light (1000 lumens)or low light (500 lumens) in the High / Low Light mode Switch.
High light mode : In fully charged can run 20 seconds x 180 times
Low light mode : In fully charged can run 20 seconds x 300 times
3.
The LED indicator will be red color while the COB LED Light is recharging. And the LED indicator will
be changed to green color as to fully charge the battery.
4. If operating time decreases significantly, a replacement battery is recommended. To replace or obtain a new
battery, contact your local Authorized Service Center.