Reference Guide
The pull-up reference guide is located on the top of the Command Center.
It provides a quick reference guide for zone locations, and a list of all the
Commands and their functions.
Digital Keypad
The Command Center has a lighted digital keypad used to enter passcodes
and system commands into the security system. As you touch the keys to
enter a passcode, the Command Center emits a short beep to indicate that
your entry is accepted.
When entering a passcode or command at the keypad, each key must be
pressed within five seconds of the last key entry. After five seconds have
expired from the last key entry, the entire entry is cleared and the passcode
must be started over.
Command Bar
The
COMMAND
bar is used to perform standard one- or two-digit
command functions.
NOTE:
Some systems require a security passcode be entered before the
COMMAND
bar can operate.
My system requires a security passcode: ____________.
My system does not require a security passcode.
If your security system has a security passcode, you must press the
COMMAND
bar after entering the passcode (plus
ENT
), in order
to enter the Command mode.
Enter Key
When the passcode has been completed, you must press the
ENT
(Enter) key to activate the passcode. If you do not press the
ENT
key,
the passcode is ignored by the security system. System commands (entries
that begin with the
COMMAND
bar) do
not
require the
ENT
k e y
to activate the entry.
Function Keys
The Command Center has three Function Keys (labeled
A
,
B
, and
C
). The
Function Keys can be used to perform system commands with the touch of
one key. Commands are not displayed when they are initiated by a Function
Key.
Function Key
Command Function Performed
Function Key
A
____________________________________
Function Key
B
____________________________________
Function Key
C
____________________________________
If a Command bar security code is required on your Command Center, it
must be entered
before
pressing the function key.
