Dear Customer,
Thank you for your purchase. Although extreme care goes into manufacturing & packaging of this product, mistakes are possible.
If you encounter any missing parts or difficulty in assembly, please contact our customer service Toll Free at
1-800-261-4112
or
for courteous & immediate resolution to your problem.
1-800-261-4112
Page 1 of 2
www.nationalpublicseating.com
Congratulations
, your Dolly is now assembled and ready to be used!
PARTS
Ensure that all Bolts are fastened tightly.
Double check all Bolts to be tightened securely before use. Check all Bolts periodically.
Failure to completely tighten the Bolts may result in tipping and possible injury!
ASSEMBLY INSTRUCTIONS
84 SERIES DOLLY
ASSEMBLING THE UNIT
A
“T” Bars x2
B
Crossbeams w/chair hangers x2
C
Base Crossbeam x1
1
Make sure that there are NO missing or
damaged parts.
While holding up one of the side
“T” Bars , bolt Crossbeam into the
middle set of holes.
B
A
Take the other side “T” Bar , and bolt it
to Crossbeam in the middle set of holes.
A
B
Take the Crossbeam , and bolt it to the
top sets of holes on both side ”T” Bars .
B
A
Finally, bolt Crossbeam , into the
bottom sets of holes on both side
“T” Bars .
C
A
C
A
4
2
5
5
3
4
HARDWARE INCLUDED
NOTE: This set of holes has three holes.
Use the two lower holes.
2
3
NOTE: This set of holes has three holes.
Use the two lower holes.
4
5
Nuts x12
A
B
B
Dolly 84 is compatible with the following NPS chairs: 50 Series, 200 Series, 300 Series, 800 Series, 1200 Series, 1300 Series,
2200 Series, 2300 Series.
Bolts
x12
All assembly should be done on a clean surface, such as carpet
or the like. Assembly is easy and should take no more than 10 minutes.
ASSEMBLY TIPS
See Page 2 for assembling unit
with Extender Bars.
OPTIONAL EXT-8
Open End
Wrench
Drill Socket
Driver
RECOMMENDED TOOLS
