![National Products 810 Скачать руководство пользователя страница 15](http://html.mh-extra.com/html/national-products/810/810_owners-manual_710305015.webp)
15
Trouble
Shooting
PST
IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If you
still experience a problem, please contact
Service Center
, Toll-free at
1-877
-
743
-
3899
from
9
AM
to
5
PM (
)
Monday through Friday. Or
®
NPL
(The warranty and customer service contact in this manual only apply in the
)
United States and Canada.
PST
email us
or visit us
www.funcreation.net
for assistance and
information from
our
trained
technical
staff
.
Check all wires and connectors. Make sure that the motor harness
connector is plugged into the battery tightly, and that there are no
loose wires around the motor.
Circuit breaker may “trip” and stop the vehicle if it is overloaded or the
driving conditions too severe. The breaker will automatically reset after
approximately 10 seconds, and the vehicle will operate normally. To avoid
repeated automatic shut downs, do not overload the vehicle by exceeding
the weight limit of 59kg, or by towing anything behind the vehicle. Do
not drive uphill or run into fixed objects, which can cause the wheels to
stop spinning while power is still being supplied to the motors. If breaker
continually trips, contact your
Service Center.
®
NPL
Car does not move
Circuit breaker tripped
Loose wire or connectors
Check all wires and connectors. Make sure that the motor harness
connector is plugged in tightly to the battery, and that there are no
loose wires around the motor.
Dead battery
An old or improperly cared battery may be dead. If you are unsure
®
whether it is dead or not, you can have it tested at your NPL
Service Center.
Undercharged battery
A new battery should have been charged for at least 18 hours before
using the vehicle for the first time. After that, it must be recharge the
battery for at least 12 hours after each use .Never charge longer than
24 hours. Check all connectors; make sure the charger is plugged into
the wall. Make sure the power flow to the outlet is on.
Charger is not working
You must have a volt meter in order to tell whether the charger is
working or not. If you think there maybe a problem with the charger ,
®
take it to the NPL Service Center where they will test it for you.
Electricity switch damages
When exposed to water or moisture, electricity can become corroded,
or can jam due to loose dirt, sand or gravel.
®
Contact your NPL Service Center for diagnosis and repair.
Loose wire or connectors
Circuit breaker tripped
Circuit breaker may “trip” and stop the vehicle if it is overloaded or
the driving conditions too severe. The breaker will automatically
reset after approximately 10 seconds, and the vehicle will operate
normally. To avoid repeated automatic shutdowns, do not overload
the vehicle by exceeding the weight limit of 59kg, or by towing
anything behind the vehicle. Do not drive uphill or run into fixed
objects, which can cause the wheels to stop spinning while power
is still being supplied to the motors. If breaker continually trips,
contact your
Service Center.
®
NPL
Car was running but
suddenly stopped
Solution
Problem
Possible Cause
Tro
ub
le
Sh
oo
tin
g
I
T
ro
u
b
le
S
h
o
o
ti
n
g
I