Installation guidelines
When installing the refrigerator into a vehicle for the first time, ensure that the electrical connections
to the vehicle’s battery are secure and the specified wiring is used.
(See wiring guidelines on page 6)
The fridge is supplied with a pre-made cable for use with a 12 / 24-volt DC supply.
This cable is terminated with a high-quality male plug for connection into your vehicle.
1. Install the supplied female
socket into your vehicle
in a convenient location.
2. Use a suitable cable to connect the
socket to the vehicle’s battery.
A cable thickness of 4mm
2
or greater is
recommended.
Centre pin ( + )
Fitting an in-line fuse
Although the fridge has a built-in fuse, it is
recommended to install an additional fuse
on the positive wire as close to the battery as
possible. This will protect against short-circuits
that may occur along the length of the cable.
Ensure that all connections are properly
crimped and insulated.
If you choose to change the attached plug on the DC cable for a different type, first ensure that the
power has been disconnected before cutting it.
Split and strip the wires as required for the new plug. Take care to ensure that the correct polarity is
used on the plug and crimp the connections where possible.
An automotive fuse with a rating
of 15A is recommended
When installing electrical outlets in your vehicle, do
not rely on the vehicle’s body for an electrical earth.
5
Male Plug
Female Socket
