NI WSN-3226 User Guide and Specifications
6
ni.com
Figure 3.
Attach the Antenna to the Device
Mounting the NI WSN-3226 Device
You can mount the NI WSN-3226 on a panel or on a 35 mm DIN rail. For kit accessory ordering
information, refer to the NI WSN product page accessory section at
ni.com
. Before using any of these
mounting methods, remove and save the serial number sticker located on the back of the NI WSN-3226
device for future use when configuring your device in software. For the NI WSN-3226 device
dimensions, refer to Figure 2.
Caution
Your installation
must
allow 50.8 mm (2 in.) of clearance in front of devices for common
connector cabling, such as the 18-terminal detachable screw terminal connector.
Attaching the NI WSN-3282 DIN Rail (Optional)
You can mount the NI WSN-3226 on a standard 35 mm DIN rail using a NI WSN-3282 DIN rail clip,
NI part number 781074-01. Complete the following steps to mount the NI WSN-3226 on a DIN rail:
Caution
Power off the device before mounting it to the DIN rail.
Note
Use thread-forming screws to permanently affix the DIN rail clip to the device. Unscrewing
and reinstalling the thread-forming screws will produce a compromised connection between the DIN
rail clip and the device.
1.
Fasten the DIN rail clip to the NI WSN-3226 using a number 2 Phillips screwdriver and the
four 8-32
×
5/16 in. thread-forming screws that shipped with the DIN rail clip(s). Figure 4 shows
how to fasten the DIN rail clip to the NI WSN-3226.
Caution
Do
not
use screws longer than 5/16 in. to fasten the DIN rail clip to the NI WSN-3226.
NATIONAL
INSTRUMENTS
NA
TIONAL
INSTRUMENTS
