NI-VXI™ is a trademark of National Instruments Corporation. Product and company names are trademarks or trade names of their respective
companies.
321528A-01˜
© Copyright 1997 National Instruments Corp. All rights reserved.
March 1997
VXI-TB-1000
T
ERMINAL
B
OARD
C
ARRIER
This guide describes how to connect signals and install the VXI-TB-1000
terminal board carrier with your VXI-DAQ module, including VXI-MIO,
VXI-SC, and VXI-DIO modules.
Introduction
The VXI-TB-1000 is a carrier for VXI-TB Series terminal boards. You
can configure these terminal boards to match any VXI-DAQ module
configuration. The VXI-TB-1000 populated with terminal boards can
easily accommodate thermocouples, RTDs, strain gauges, thermistors,
millivolt sources, volt sources, and current-loop receivers.
What You Need to Get Started
You need the following items to set up and use your VXI-TB-1000
terminal board carrier:
❑
One or more VXI-TB-1000 terminal blocks
❑
One or more VXI-TB Series terminal boards
❑
VXI-TB-1000 Terminal Board Carrier Installation Guide
❑
VXIbus chassis
❑
One or more VXI-DAQ modules and documentation
❑
Phillips-head number 1 and number 2 screwdrivers
❑
0.09 in. flathead screwdriver
❑
Long-nose pliers
❑
Wire cutter
❑
Wire insulation stripper
