National Instruments Two-Slot Embedded Controller NI PXI-8183, Руководство по установке

Страница: 3 / 4

© National Instruments Corporation 3 NI PXI-8183 Installation Guide
11. Connect the VGA monitor video cable to the VGA connector.
12. Connect devices to ports as required by your system configuration.
13. Power on the chassis.
14. Verify that the controller boots. If the controller does not boot, refer to
the What If the NI PXI-8183 Does Not Boot? section.
Figure 2 shows an NI PXI-8183 installed in the system controller slot of a
National Instruments PXI-1036 chassis. You can place PXI devices in any
other slot.
Figure 2. NI PXI-8183 Controller Installed in a PXI Chassis
How to Remove the Controller from the PXI Chassis
The NI PXI-8183 controller is designed for easy handling. To remove the
unit from the PXI chassis:
1. Power off the chassis.
2. Remove the bracket-retaining screws in the front panel.
3. Press the injector/ejector handle down.
4. Slide the unit out of the chassis.
1 PXI-1036 Chassis 2 NI PXI-8183 Controller 3 Injector/Ejector Rail
NA
TIO
NAL
INSTRU
MEN
TS
1
2
3
NI PXI-1036
LO
W PO
WER