©
National Instruments Corporation
7
BNC/TC-2095 Rack-Mount Adapter Installation Guide
Caution
Refer to the
section before connecting the signals. If signal
wires are connected to the terminal block, dangerous voltages can exist even when the
equipment is powered off.
1.
Power off the SCXI chassis.
2.
Power off the computer that contains the E Series data acquisition
(DAQ) device, or disconnect the computer from the SCXI chassis.
3.
Connect the TBX cable adapter to the SCXI module, and secure the
adapter by tightening both thumbscrews.
4.
Connect either end of the SH96-96 cable to the TBX cable adapter and
SCXI module, and secure the cable by tightening both backshell
mounting screws.
Figure 1.
Connecting the SH96-96 Cable to the SCXI Module
5.
Mount the BNC/TC-2095 onto a 19-in. rack or place it on a workbench
near the SCXI chassis. If you do not rack-mount the BNC/TC-2095,
attach the four adhesive rubber feet included in the kit to the bottom of
the adapter to keep it stationary.
1
Backshell Mounting Screws
2
SH96-96 Cable
3
Thumbscrews
4
SCXI Chassis
5
TBX Cable Adapter
3
4
3
1
5
1
2
5
4
3
2
1
ADDRESS