NI TB-2676 Installation Instructions
2
ni.com
3.
Loosen the two screws on the strain-relief assembly and remove the
top strain-relief bar.
4.
Connect the safety earth ground to a safety ground lug.
5.
Connect the ribbon cables or wire wraps to the ribbon cable headers.
When connecting a signal, refer to the terminal reference diagram in
Figure 2.
6.
Pull the cables through the strain-relief opening to remove the slack in
the wiring.
7.
Replace the strain-relief bar and tighten the two screws on the
strain-relief assembly to secure the cables.
8.
Replace the terminal block top cover.
9.
Secure the terminal block top cover with the top cover screw.
Figure 1.
NI TB-2676 Terminal Block
1
Terminal Block Top Cover
2
Top Cover Screw
3
Safety Ground Lug
4
Chassis Screws
5
Strain-Relief Screws
6
Strain-Relief Opening
7
Strain-Relief Bar
8
Ribbon Cable Headers
9
Rear Connector
4
4
8
2
3
1
5
5
7
6
9
