Chapter 1
Installing and Configuring the SCXI-1126
©
National Instruments Corporation
1-11
Installing the SCXI-1126 Module into the SCXI Chassis
To install the SCXI-1126 module into the SCXI chassis, complete the
following steps while referring to Figure 1-2:
1.
Power off the computer that contains the E Series DAQ device, or
disconnect it from the SCXI chassis.
2.
Power off the SCXI chassis. Do
not
insert the SCXI-1126 module into
a chassis that is powered on.
3.
Insert the SCXI-1126 into an open slot in the SCXI chassis. Gently
guide the module into the slot guides and push it toward the back of the
chassis until the front face of the module is flush with the front of the
chassis.
4.
Insert any other SCXI modules into the remaining slots in the same
manner as described in step 3.
5.
Secure all the SCXI modules to the SCXI chassis using both
thumbscrews.
Figure 1-2.
Installing the SCXI-1126 Module
To complete the SCXI-1126 installation, follow the procedure in the
appropriate sections that follow.
1
SCXI Chassis Power Switch
2
SCXI Chassis Slots
3
SCXI Module Thumbscrews
®
5
4
3
2
1
ADDRESS
1
2
3
