National Instruments SC-205 Series, Руководство пользователя

Страница: 69 / 119

Chapter 8 SC-2056
© National Instruments Corporation 8-5 SC-205X Series User Manual
Table 8-1 describes the connectors on the SC-2056.
Table 8-1. SC-2056 Connectors
Connectors Connection Description
J1 100-pin female ribbon cable
shielded connector; DAQ
device connection Attach J1 to the DAQ device when using the
SH100-100 or SH96-100 cable.
J2 50-pin male ribbon cable
connector; DAQ device
connection (pins 1–50) Attach J2 to the DAQ device pins 1–50 when
using the R1005050 cable.
J3 50-pin male ribbon cable
connector; DAQ device
connection (pins 51–100) Attach J3 to the DAQ device pins 51–100 when
using the R1005050 cable.
J4 50-pin male ribbon cable
connector; analog input
channels 0–15 Attach J4 to the 50-pin accessories as shown in
Figure 8-2.
J5 50-pin male ribbon cable
connector; analog input
channels 16–31 Attach J5 to the 50-pin accessories as shown in
Figure 8-2. 50-pin accessories are labeled
channels 0–15. This connector uses channels
16–31 of the DAQ device.
J6 50-pin male ribbon cable
connector; analog input
channels 32–47 Attach J6 to the 50-pin accessories as shown in
Figure 8-2. 50-pin accessories are labeled
channels 0-15. This connector uses channels
32–47 of the DAQ device.
J7 50-pin male ribbon cable
connector; analog input
channels 48–63 Attach J7 to the 50-pin accessories as shown in
Figure 8-2. 50-pin accessories are labeled
channels 0–15. This connector uses channels
48-63 of the DAQ device.
J8 26-pin male ribbon cable
connector; digital I/O
connection Attach J8 to the SC-206 X Series or SSR
8-channel boards. This connection takes the
eight digital I/O lines from the DAQ device to a
digital signal conditioning accessory with
compatible pin connections, as shown in Figure
8-2.