Chapter 6
SC-2054
6-2
©
National Instruments Corporation
Figure 6-1 shows the SC-2054 parts locator diagram.
Figure 6-1.
SC-2054 Parts Locator Diagram
SC-2054 Connection
Your SC-2054 is connected to the 96-channel DAQ device via a type NB5,
100-pin ribbon cable or R1005050 ribbon cable depending on the device.
Make this connection with the host computer powered off. Connect one of
the 50-pin connector ends of the cable to the SC-2054 at connector J1.
Connect the 100-pin connector end of the cable to the DAQ device installed
in your computer.
Warning
Do not connect the SC-2054 to a board for which it is not designed. Such
connection can damage the SC-2054 and any or all boards/accessories connected
to the SC-2054 and host computer. National instruments is
NOT
liable for any
damages resulting from incorrect connections.
1
Product Name, Assembly Number, Revision Letter, and Serial
Number
2
Shield Jumper
3
To DAQ Device
4
To CB-50
5
To 16-Channel or 24-Channel SSR
6
To SC-206
X
Series or 8-Channel
SSR
1
2
3
4
5
6
