Step 3: Install LabVIEW and Add-Ons
Make sure the following versions of
LabVIEW™
and required add-ons are installed:
1.
LabVIEW™
2013 or later
2. NI-DAQmx 9.8 or later
3. NI ELVISmx 4.5 or later
Step 4: Setup Hardware
To setup the QNET Mechatronics Interfacing, please read the following instructions carefully. For full details, see
the QNET Mechatronic Interfacing User Manual.
Ensure that the NI ELVIS
II
(+)
power switch is in the off
position.
A
Place the handle on the front of the QNET
board over the bracket located on the front of
the NI ELVIS II
(+)
.
B
Slide the PCI connector at the back of the
QNET board into the female connector on the
NI ELVIS II
(+)
.
C
QNET MI Quick Start Guide
2