National Instruments PXIe-8246, Начало работы, Страница: 8 / 12

10. Connect an Ethernet cable to a GigE Vision camera, then connect the camera
to the PXIe-8246 front panel.
11. Power on the chassis.
Note
The first time you start the development computer after
installing the hardware, allow several seconds for the drivers to load.
Confirming the Device is Recognized
To confirm that the device is properly installed and the hardware is recognized,
complete the following steps:
1. Select
Start
»
All Programs
»
National Instruments
»
Measurement &
Automation Explorer
to open Measurement & Automation Explorer (MAX).
2. Verify that the camera connected to the PXIe-8246 appears under
My
System
»
Devices and Interfaces
»
NI-IMAQdx Devices
.
Front Panel
The following figure shows the PXIe-8246 front panel.
ni.com
8
PXIe-8246 Getting Started