![background image](http://html1.mh-extra.com/html/national-instruments/pxie-5774/pxie-5774_getting-started-manual_3622830006.webp)
Figure 2. Module Installation
2
3
NI PXIe-1075
1
1. Chassis
2. Hardware Module
3. Ejector Handle in Downward (Unlatched) Position
9.
Latch the module in place by pulling up on the ejector handle.
10. Secure the module front panel to the chassis using the front-panel mounting screws.
Note
Tightening the top and bottom mounting screws increases mechanical
stability and also electrically connects the front panel to the chassis, which can
improve the signal quality and electromagnetic performance.
11. Cover all empty slots using EMC filler panels or fill using slot blockers to maximize
cooling air flow, depending on your application.
12. Power on the chassis.
Installing the Ferrite on the DIO Cable
Notice
To ensure the specified EMC performance, install the snap-on ferrite bead
(National Instruments part number 781233-02) in accordance with these instructions.
1.
Open the ferrite bead and place the cable inside the center of the bead. Ensure the ferrite
bead is as close to where the cable connects to the PXIe-5774 as practical.
2.
Close the ferrite bead until the locking tabs engage securely.
6
|
ni.com
|
PXIe-5774 Getting Started Guide