National Instruments PXIe-5630, Руководство по началу работы

Страница: 15 / 18

Troubleshooting
If an issue persists after you complete a troubleshooting procedure, contact NI technical
support or visit
ni.com/support .
What Should I Do if the Module Fails the Self-Test?
1. Restart the system.
2. Launch MAX, and perform the self-test again.
3. Power off the chassis.
4. Reinstall the failed module in a different slot.
5. Power on the chassis.
6. Perform the self-test again.
Related Information
Configuring the NI 5630 in MAX on page 11
Why Is the ACCESS LED Off When the Chassis is
On?
The LEDs may not illuminate until the device has been configured in MAX. Before
proceeding, verify that the NI 5630 appears in MAX.
If the ACCESS LED fails to illuminate after you power on the chassis, a problem may exist
with the chassis power rails, a hardware module, or the LED.
Caution Apply external signals only while the NI 5630 is powered on. Applying
external signals while the device is powered off may cause damage.
1. Disconnect any signals from the module front panels.
2. Power off the chassis.
3. Remove the module from the chassis and inspect it for damage. Do not reinstall a
damaged device.
4. Reinstall the module in a different chassis slot.
5. Power on the chassis.
6. Verify that the device appears in MAX.
7. Reset the device in MAX and perform a self-test.
What Should I Do if the NI 5630 Doesn't Appear in
MAX?
1. In the MAX Configuration pane, click Devices and Interfaces .
2. Expand the Chassis tree to see the list of installed devices, and press <F5> to refresh the
list.
3. If the module is still not listed, power off the system, ensure that all hardware is correctly
installed, and restart the system.
NI PXIe-5630 Getting Started Guide
|
© National Instruments
|
15