2-12
|
ni.com
Chapter 2
Installation and Configuration
The Ethernet connector has two LEDs that indicate the current status of the Ethernet link.
Table 2-1 describes the behavior of these LEDs.
Default Configuration Settings
The chassis ships from the factory with the following default configuration settings:
•
DHCP with Auto IP fallback
•
Default hostname as printed on the product label
Chassis LED Indicators
The PXIe-1066DC chassis has four main LEDs on the front panel next to the Power Inhibit
switch. Refer to Figure 1-1,
Front View of the PXIe-1066DC Chassis (with Optional Filler
, to locate these LEDs.
Table 2-1.
Ethernet LED Behavior
LED
State
Description
ACT/Link
Off
Link is not established.
Steady green
Link is established.
Blinking
green
Chassis is communicating with another device on the
network.
10/100
Off
10 Mbps data rate is selected.
Steady green
100 Mbps data rate is selected
