INSTALLATION GUIDE
NI PXI-8195/8196
This document contains information about installing your
NI PXI-8195/8196 controller in a PXI chassis. For complete configuration
and troubleshooting information (including information about BIOS setup,
adding RAM, etc.), see the
NI PXI-8195/8196 User Manual
. The manual is
in PDF format on the recovery CD included with your controller and on the
National Instruments Web site,
ni.com
.
Installing the NI PXI-8195/8196
This section contains general installation instructions for the
NI PXI-8195/8196. Consult your PXI chassis user manual for specific
instructions and warnings.
1.
Plug in your chassis before installing the NI PXI-8195/8196. The
power cord grounds the chassis and protects it from electrical damage
while you install the module. (Make sure the power switch is
turned off.)
Caution
To protect both yourself and the chassis from electrical hazards, leave the chassis
off until you finish installing the NI PXI-8195/8196 module.
2.
Remove any panels blocking access to the system controller slot
(Slot 1) in the chassis.
3.
Touch the metal part of the case to discharge any static electricity that
might be on your clothes or body.
4.
Remove the protective plastic covers from the four bracket-retaining
screws as shown in Figure 1.
5.
Make sure the injector/ejector handle is in its downward position.
Align the NI PXI-8195/8196 with the card guides on the top and
bottom of the system controller slot.
