©
National Instruments Corporation
3
Using the PXI-8150B/8170 Series in a PXI-1020 Chassis
4.
From the main CMOS Setup Utility screen, select BIOS FEATURES
SETUP using the arrow keys and then press the <Enter> key.
5.
In the BIOS FEATURES SETUP screen, use the arrow keys to
highlight the boot sequence entry and change it to
A,C,SCSI
by
pressing the <Page Up> key.
6.
Press the <Esc> key once to return to the main CMOS Setup Utility
Screen and then press the <F10> key to save and exit. Reply to the
prompt by typing
Y
to confirm saving the new CMOS settings.
7.
Your controller will now boot from the floppy drive.
Step 2d. Set the Controller BIOS to Enable the
LCD Signals
1.
Follow the instructions on the screen to update the FLASH BIOS to
enable the LCD function.
2.
Power off the system.
3.
Remove the floppy disk from the floppy drive.
4.
Reboot the system with the external monitor still connected. If this is
the first time you boot your PXI controller from the hard disk, follow
the instructions on the screen to register your operating system and to
register any installed software options.
5.
Select Start»Control Panel»Display»Settings to change the number
of colors while in 640
×
480 resolution.
6.
Shut down Windows and power off your PXI-1020 chassis.
7.
Remove the VGA cable from the PXI controller.
8.
Reboot the system and verify that your LCD is working.
Содержание PXI-8150B
Страница 6: ......
