Chapter 2
Installation and Configuration
©
National Instruments Corporation
2-13
•
Discard Changes
—Any changes made to BIOS settings during
this session of the BIOS setup program are discarded. Unlike
Exit
Discarding Changes
, however, the BIOS setup continues to be active.
•
Save Changes
—Changes made to BIOS settings during this session
are committed to battery-backed System CMOS. The setup program
remains active, allowing further changes.
System CMOS
The NI PXI-8106 contains a backed-up memory used to store BIOS
configuration information.
Complete the following steps to clear the CMOS contents:
1.
Power off the chassis.
2.
Remove the controller from the chassis.
3.
Move the jumper on W7 from pins 1–2 to pins 2–3, as shown in
Figure 2-3.
4.
Wait one second. Move the jumper back to pins 1–2.
5.
Reinstall the controller in the chassis.
Caution
Do
not
leave the jumper on pins 2–3. Doing so decreases battery life. In addition,
leaving the jumper on the pins prevents the controller from booting.
